I also used a pretty long screwdriver but still had no screwdriver access when I got down to the last screw. I could get 3 of the screws in,I took care not to tighten them a lot, just barely holding on, and still the fourth screw just couldn't align, after a lot of time I managed to push it in but it wasn't straight and I was afraid I'd strip the threads. I installed with the cooler facing the rear, normally it should be facing the top on an AMD system as I understand it. Then I had a VERY VERY hard time getting all four spring screws to adjust and tighten properly on my AMD board. The easy part was to install and secure the backplate and risers. I just installed it, temps look good but is it secure enough?
0 kommentar(er)
